Cooper-instruments-systems DFI 7000 Digital Force Indicator Bedienungsanleitung

CF11 1 V-May 2003-008-0186-00 DFI 7000 DIGITAL FORCE INDICATOR USER’S GUIDE 1.0 INTRODUCTION The DFI 7000 Signal Conditioner-Indicator is a com

CF11 10 V-May 2003-008-0186-00 9.0 WARRANTY REPAIR POLICY Limited Warranty on Products Any Cooper Instruments product which, under normal operati

CF11 2 V-May 2003-008-0186-00 AMPLIFIER CHARACTERISTICS Full-Scale Output 5 Volts Output Impedance <2 ohms Accuracy +/-0.03% Frequency Respon

CF11 3 V-May 2003-008-0186-00 3.2 Mounting the Unit For panel mounting, cut a rectangular hole 3.58” in width by 1.73” in height. Remove the panel

CF11 4 V-May 2003-008-0186-00 button on the front panel, or by interconnecting the RESET and COMMON terminals momentarily on the rear connector.

CF11 5 V-May 2003-008-0186-00 14.7 psi) and adjustment cannot be made using the ZERO adjustment only. 1. Remove the bezel and front panel with a

CF11 6 V-May 2003-008-0186-00 4.3 Scaling Adjustment Scaling adjustment permits the DFI 7000 to display values in the engineering units desired by

CF11 7 V-May 2003-008-0186-00 3. Carefully pull the Main Board out of the unit. All boards will come out simultaneously. 4. Gently remove the Si

CF11 8 V-May 2003-008-0186-00 7.1.1 Setting The Limits Adjustments Proceed to adjust as follows: 1. Unplug the AC power and remove the bezel and f

CF11 9 V-May 2003-008-0186-00 track the input signal unless the HOLD mode is active. The AMP OUT terminal will always track the input signal regar